| Input frequency range | 0.01-30 MHz (direct input section), 30-3000 MHz (heterodyne section),
separate SMA inputs, paths internally switchable |
| Tuning resolution | 1 MHz |
| Output frequency | 70 MHz |
| Output bandwidth | 22 MHz |
| Gain | 30 dB typ. |
| Noise figure | 15 dB typ. |
| Internal spurii | less than -100 dBm of eq. antenna input
except for 30 MHz reference clock at typ. -70 dBm
and its multiples at less than -90 dBm typ. |
| IF rejection | >40 dB typ. |
| Image rejection | >40 dB typ. |
| Maximum input level | +10 dBm |
| Attenuation control | 0-20 dB in 1 dB steps
(30 to 3000 MHz path only)
|
| IP3 | -3 dBm @ 1060 MHz with interfering signals at 1040 MHz and 1050 MHz |
| Input impedance | 50 ohm (SMA connector) |
| Output impedance | 50 ohm (SMA connector) |
| Amplitude ripple | 3 dB typ. |
| Phase ripple | 3 degrees typ. |
| Phase adjustment range | 60 degrees |
| Phase adjustment resolution | 0.25 degrees |
| Channel-to-channel isolation | 40 dB typ. |
| Total phase noise | -86 dBc/Hz @ 10 kHz offset (30 MHz internal ref.) |
| Tuning speed | 5 ms typ. |
| Frequency stability | 1 ppm (or external reference) |
| External reference | 10 MHz or 30 MHz (-5 dBm to +15 dBm) |
| LO1 | 3950 to 6920 MHz (accessible to the user at 0 dBm +/- 5 dB via SMA LO1 Out) |
| LO2 | 3850 or 3990 MHz (accessible to the user at +5 dBm via SMA LO2 Out) |
| IF1 | 3920 MHz (accessible to the user with 0 dB gain, 30 MHz BW, SMA output) |
| Phase-coherent capability | Inbuilt two-way splitters on LO1 and LO2 for two-channel phase-coherent operation |
| HF Mode Preselector | Switchable AM BCB filter |
| HF Mode Preamplifier | 20 dB switchable |
| HF Mode Antialiasing Filter | 30 MHz LPF |
| Power consumption | 6 W typ. |
| Control interface | USB 2.0 or RS-232C |
| Dimensions | 91 x 68 x 47 mm (3.6" x 2.7" x 1.9") |
| Weight | 375 g (13.2 oz) |
| Operating temperature | -10º to +60º C |
| Humidity | 20-90% non-condensing
|
